Dishlex DX301SK User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
The water pressure must be in the limits (refer to
'Technical data'). Make sure that the local water au-
thority gives you the average mains pressure in your
area.
Make sure that there are no kinks in the water inlet
hose and that the water inlet hose is not squashed or
entangled.
Fit the hose nut correctly to prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that have been not used for a
long time. Let the water run for some minutes, then
connect the inlet hose.
Water drain hose
The highest point of the drain hose must be no more
than 60 cm from the floor and must have a continu-
ous fall.
The drain hose can be lengthened using additional
lengths and connectors. These must be purchased
from Electrolux Spare Parts. The extension length
must not exceed 2 metres.
The drain hose must be free of kinks and obstruc-
tions.
Remove the sink plug when the appliance drains the
water to prevent that the water goes back into the ap-
pliance.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane. If you
do not remove the membrane, remaining food can
cause a blockage in the drain hose spigot.
The appliance has a security feature to prevent dirty
water going back into the appliance. If, the spigot of
the sink has a 'non-return valve', this valve can cause
the appliance to drain incorrectly. Remove the non-
return valve.
Make sure that the water couplings are tight to pre-
vent water leakage.
Caution! Ensure that hoses are not crushed or
kinked under or behind the appliance.
Caution! Once connected the inlet hose to the
water tap, turn the tap on and check that there
are no leaks.
Electrical connection
Warning! Safety standards require the
appliance to be earthed.
Prior to using the appliance for the first time, ensure
that the rated voltage and type of supply on the rating
plate match that of the supply where the appliance is
to be installed.
The fuse rating is also to be found on the rating plate.
Always plug the mains plug onto a correctly installed
approved socket.
Do not use multi-ways plugs, connectors and
extension cables. This can constitute a fire hazard
through overheating.
17
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments