Malfunction Fault code Possible cause Possible solution
Mains plug is not connec-
ted.
Plug-in appliance to the
mains.
The fuse has blown out in
the household fuse box
Replace the fuse.
The delay start is set. If you want to cancel the de-
lay start, refer to 'Select and
start a washing program'.
After the check, switch on the appliance. The pro-
gram continues from the point of interruption. If the
malfunction shows again, contact your Customer
Care Centre.
If the display shows a fault code, not described in the
chart, contact your Customer Care Centre.
These data are necessary to help you quickly and
correctly:
For these data, refer to the rating plate.
Write the necessary data here:
Model (MOD.) ....................
Product number (PNC) ....................
Serial number (S.N.) ....................
The cleaning results are not satisfactory
The dishes are not clean • The selected washing program is not applicable for the type of load and
soil.
• The baskets are loaded incorrectly so that water cannot reach all surfa-
ces.
• Spray arms do not turn freely because of incorrect arrangement of the
load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
The dishes are wet and dull • No rinse aid has been used.
• The rinse aid dispenser is empty.
There are streaks, milky spots
or a bluish coating on glasses
and dishes
• Decrease the rinse aid dosage.
Dry water drop stains on
glasses and dishes
• Increase rinse aid dosage.
• The detergent can be the cause.
14
Comments to this Manuals